How to make a super easy fall salt shaker tassel

In this tutorial, you will see how easy it is to use up all your leftover ribbon scraps, fabric scraps, rick-rack, and trims to make this adorable fall salt shaker tassel. The Bowdabra holds all your scrap trims together, and the Bowdabra bow wire makes it easy to thread through the holes!

Materials:

Scrap trims, ribbons, beads, and fabric scraps

Bowdabra bow maker

Bowdabra bow wire.

Beads of choice

Salt shaker pumpkin

Instructions:

First, cut all your trims, fabrics, and more to approximately 15 inches.

Next, cut a length of Bowdabra bow wire, fold it in half, and place it in the Bowdabra. You will have a loop on one side and two loose wires on the other.  This will be your slip knot to hold your tassel together.

Now, find the middle of each scrap piece and begin adding your tassel trims one at a time. When you have added all your trims, scrunch down with the Bowdabra wand.

Thread the loose bow wire through the loop and pull tight, holding down on your tassel.  Remove from the Bowdabra, separate the ends, and tie a knot. Turn to the back and tie several more knots, pulling tightly.

Next, remove the plastic stopper from the bottom of your salt shaker and carefully thread each end of the bow wire through the holes at the top. If you hold it up to the light or over a white surface, it makes it easier to find the holes.

Now, pull the Bow wire tightly and adjust the tassel. Tie the two bow wires together at the top of the salt shaker. Thread some beads on the wires and tie a knot. Make a loop for hanging and tie a knot.

Fluff your fall salt shaker tassel and trim the ends evenly if necessary.  Hang on hooks, pictures, wreaths, lamps, or anywhere you want a little fall décor!