With holiday gatherings near, here’s an easy and quick DIY on how to make a super cute Cornucopia and Bow decor for Fall! Impress your family and friends with this lovely decorative piece. Imagine it overflowing with seasonal items such as leaves, acorns, nuts, candies, and other goodies! The possibilities are endless!
Once you line up the burlap edges and point into a cone, run glue along the edges where they overlap to hold the cone in place, to make . . .
the cornucopia shape.
To dress up the cornucopia with ribbon, take a 50″ piece of wired ribbon and . . .
fold together lengthwise. Use clamps to hold the ribbon together. Pull the end wire on each side gathering the ribbon into ruffles.
To make the Bowdabra Bow, cut a 15″ piece of Bowdabra bow wire, fold it together, and place it in the Mini Bowdabra. Tuck the ends under. Cut an 18″ piece of matching ribbon, creasing the center, and place it down into the Mini Bowdabra.
Next, leave the ribbon on the roll and then, crease about an inch from the end of the ribbon and insert it down into the Mini Bowdabra. Then, fold over a four-inch loop and press down into the Mini Bowdabra.
Fold the ribbon to make a matching loop on the opposite side, down into the Mini Bowdabra.
Then, make two more loops on either side for a total of four loops.
Remove the Mini Bowdabra wand and thread the two loose ends of the bow wire through the loop, pulling tightly and gently pulling it out. Take the bow wire around to the back, tying the wire in two or three tight knots. Cut off the excess wire.