How to make the cutest bunny hoop wreath with a Bowdabra bow

Large Bowdabra

2-inch floral ribbon

2-inch holey burlap ribbon

1-inch burlap ribbon

4 picks of greenery of choice

Four flowers of your choice

4 flower buds of choice

Scissors

Wire cutters

Bowdabra wire

First, we are going to begin by loading our Bowdabra with 24-inch Bowdabra wire folded in half. Next, place the first two pics of greenery. Two picks will go on the left side and two picks will go on the right side. After we have our greenery set we will start putting in our flowers. We should end up with two large flowers on each side as well as two flower buds on each side.

Once our greenery and florals are in place, we will begin making our bow. We begin by placing our tails down into the Bowdabra. Each tail will be 14 in long equaling 7 in tails.  I like to start with my pattern ribbon first, then my holey burlap ribbon, and lastly the solid one-inch burlap ribbon.

After the tails are placed in the Bowdabra, we will begin making our first set of loops with our floral ribbon. Each loop will be 4 in long making sure we are twisting the ribbon in the center so the exposed ribbon is our pattern side. We will end up with three loops on each side. Next, load the holey burlap ribbon into the Bowdabra, we will have two loops on each side. We’ll end our bow by placing one loop on each side with our 1-in burlap ribbon.

Make sure to press all of the ribbon in the greenery down in your Bowdabra using your hand or the Bowdabra wand. Lift up the Bowdabra wire. Place the two loose strings into the hole of the wire and pull tight. Separate the strings and flip your swag over and tie the wire tight in the back.

To attach your swag to your bunny-beaded hoop wreath simply tie the Bowdabra wire onto the frame! Thank you so much for following along with me. Happy crafting!!

Be sure and visit Britts creations on Facebook!

-Britt’s Creations