Bowdabra designer, Joette is here to show you how easy it is to make an amazing Star Wars themed lightsaber wedding bouquet. How much fun is that?
Supplies:
(Supplies may vary because of sizes, colors, etc… The list here is for this particular wedding.)
First, gut the flash light/s and remove the switch, glass & glass cover. Next, spray paint until it is completely coated. Use E-6000 and glue the soda lid to the bottom with the open end facing outward. E-6000 the ping pong ball to the open end of the lid. When completely dried, add the switch & glass cover back on. The switch may need a dab of E-6000.
Place a zip tie in the Large Bowdabra. Now, lay in some foliage. Then, start layering the flowers on top of the greens. As you’re layering the flowers, break them up by sizes and colors. Once you have the desired amount of flowers in the Bowdabra Bouquet, add the same kind and amount of the greenery foliage as you did on the bottom.
Gently zip tie the bouquet, but not extremely tight yet. Remove it from the Bowdabra & give it a little bit of fluffing and shaping. Once it’s all in place, then you can tighten the zip tie.
Clip the excess zip tie & trim the Bouquet stems all evenly. You can use floral tape on them if you wish now. Place some hot glue on the stems and push them straight down into the floral foam inside the flashlight/lightsaber. Do a touch-up fluffing & shaping one more time and that’s how you make a Star Wars-themed wedding bouquet with Bowdabra!
