This adorable and fun bunny wall hanging will brighten your home and get everyone excited for Spring and Easter! Made of foam board covered in burlap, adorned with flowers and bow, resulting in an adorable Easter bunny wall hanging. The wall hanging will look great on a wall or the front door – the perfect addition to your Easter decor!
Supplies:
Instructions:
Let’s begin by drawing the bunny’s head and ears using a large pan top on a poster board for a template.
Next, use scissors to cut out and . . .
apply tacky glue all over the template and . . . 
glue to poster board. Use a craft knife to cut out the bunny head image.
Add a light layer of Mod Podge to the bunny head and . . .
apply burlap, smoothing the fabric out over the entire bunny head. Trim burlap around leaving an inch border. Cut slits in the fabric to . . .
overlap edges and glue to backing. Let dry. The back can be covered with additional burlap following the outline of the bunny head.
Next, begin gluing on the twisted rope using hot glue along the edge between the bunny ears, moving around the ears and . . .
face until reaching back where it began between the ears.
Next, glue on eyes, nose . . .
mouth and flowers.
Fold a 24″ piece of Bowdabra wire in half and lay it in the Bowdabra, tucking ends under. Measure 8″ of 2.5″ ribbon for the tail and make a crease in the middle, placing the ribbon at the crease mark and place it down into the center of the Bowdabra.
Next, leave the ribbon on the roll to make your first loop. Fold over and make a crease into the ribbon creating a five-inch loop and press into the Bowdabra.
Next, fold the other side at the same width creating another five-inch loop.
Continue making one more loop on either side for a total of four, 5″ loops. Then fold the end ribbon, creating a button loop. Cut off the excess ribbon.
Then scrunch the ribbon down with the Bowdabra wand.
While the bow is still in the Bowdabra, thread the two loose ends of the Bowdabra bow wire through the loop at the other end.
Pull the Bowdabra bow wire tightly while the bow is still in the Bowdabra and gently pull the bow out of the Bowdabra. Separate the loose wire ends and take them around to the back of the bow and tie in several knots to secure. Cut off excess wire. Straighten and fluff bow.
Fold the end ribbon together and cut at the fold on an angle down to the opposite ribbon edge.
How adorable is this bunny wall hanging? It can be featured on the front door or . . .
hang it on a wall
