Wine Cork Christmas Reindeer

It’s Christmas in July! And I’m busy as any elf working on some Christmas projects for your enjoyment. Start now and you will be all ready when time seems to be at a premium during the holidays. When Christmas rolls around you can hang this little guy on the tree or just stand him upright. Use the Mini Bowdabra tool to make him a perfect little bow tie.

You will need:

• Two wine corks
• 2 ½” wooden picks (available in craft stores)
• Ruler
• Marker
• Heavy scissors
• Two geometric colored paper clips
• Wiggle eyes
• Small red pom pom
• Tacky craft glue
• Small pointed awl
• 10 inches of 7/8” wired Christmas print ribbon (You may substitute solid color ribbon if desired)
• Bowdabra Bow Wire
• Mini Bowdabra with Hair Bow Tool and Ruler

Instructions:

1. Mark four dots on the underside of one wine cork for the leg.

 

2. Turn over and make another mark about ½” from the edge centered between the opposite side leg marks. (Neck mark)

3. Use the awl with a twisting motion to drill holes about ¼” down in the four leg mark areas. Turn over and do the same with the neck hole mark.

 

4. Measure 1 ½” from a wooden pick and cut with heavy scissors. Repeat for three more picks. You will have a total of four 1 ½” legs.

 

5. Use the leftover pick from one of the legs to cut a 1” piece for the neck.

6. Dab a bit of tacky glue on the ends of each prepared leg pick and insert into the holes you made. Make sure you insert them the same lengths. You can measure by standing upright.

 

7. Insert the 1” pick piece in the neck hole.

 

8. Measure ¾” from the end of a second wine cork, mark and make a hole. Add some glue to the end of the wood pick in the body hole and insert the second cork.

 

9. Pry apart a colored geometric shaped paper clip. Use the awl to make two holes on the top of the head and insert an opened paper clip on each side. (Antlers made)

 

10. Add two dots of tacky glue on the top of the reindeer and attach two wiggle eyes. Glue on a small red pom pom on the front for a nose.

 

11. Make a mini bow tie. Using the Mini Bowdabra with ruler attached, insert a 6-inch piece of bow wire lengthways.

 

12. Cut a piece of 7/8” wide printed wired ribbon. Place the ribbon into the Mini Bowdabra to create a 1” tail. Next, fold the ribbon to form a loop at the 1” mark.

 

13. Fold a matching loop on the other side and trim the ribbon at the 1 inch mark. Use the wand to scrunch down the ribbon.

 

14. Pull the wire tightly.

 

15. Remove the bow and tie a knot on the back. Trim the wires short.

 

16. Fluff and arrange the bow. Add some tacky glue onto the back of the bow and attach to the front of the reindeer.

 

17. Your reindeer is complete.

For more about the designer click here…..